mugen gear change

[vsnitro]

Hey folks! iam chaning up gearing in the rear diff. 11t beavel/38t conical/10t diff/48t spur the idea is get higher RPM's for punch out of the corners. any comments? has anybody done this?

[LUV DA AIR]

Hey folks! iam chaning up gearing in the rear diff. 11t beavel/38t conical/10t diff/48t spur the idea is get higher RPM's for punch out of the corners. any comments? has anybody done this?Did you post this ? oner on NEO? anyways.........

I would do both FRONT and REAR if I was doing this. If your looking for more punch or hit out of the corners try some clutch tuning. There is a TON of "punch" to be found there.:thumbs:

[vsnitro]

Did you post this ? oner on NEO? anyways.........

I would do both FRONT and REAR if I was doing this. If your looking for more punch or hit out of the corners try some clutch tuning. There is a TON of "punch" to be found there.:thumbs:or

Yea i did post this on neo!! actually i think i posted this on a few others aswell!! Thanks for the comment. Yea i just bought some racers edge aluminums and was going to try some diff setups with that. i just wanted to try something diff. in the gearing. with the o.s. speed kindof an experiment :rock:

[LUV DA AIR]

aluminums grab really well, but I cant get past how noisy they are. It always sounds to me as if the bell bearing are going out. here is a great thread for some more ideas for you.

http://www.nitroaddicts.com/forums/showthread.php?t=339