help with my t-maxx 3.3

[J-dub-u]

alright so im having some problems with my t-maxx. when ever i shift into reverse and then go to drive forward again nothign happens. i give it gas and nothing the servo for the throttle doesnt even move, then eventually it goes forward, and then some times it just cuts out. i try shuting the controller off quick then turning it back on nothing, if i give the truck a little push or shake it sometimes goes and some times nothing until it stalls and i start it up again. does any one know what's going on, or ever had this problem?

[AZRCaddict]

Sounds like you need a new servo. Do you have a spare sitting around just to test out? If you do then plug it into that servos spot and see what happens to make sure it isnt the reciever

[RC_KAOS]

I take it that it is a new one?

Cheers

[rubber side up]

i got a good solution... forward only conversion :p

just check all your radio gear. take one servo out at a time an see if everything still works.

[Savagekilla]

Check the servo wires tht go into the reciever .. They can be loose :grin:

[RC_KAOS]

Has it gone through any water/snow etc.?

Cheers

[J-dub-u]

no i havent drove it in any rain, and its pretty new , i wil check my servo cause i just noticed my steering servo was cracked so there might be soenmthing wrong with it to thanks for the help guys

[greystonerc]

i had the same prob. with mine and all i done was adjust the linkage cause the reverse shaft wasnt going all the way in...:thumbs: hope this helps

[MUGENPOWERX]

or if the shaft is in all the way and you give it some gas and it doesnt move forward it can also be the little allen bolt that holds one of the gears stationary to the shaft inside the tranny ,so youll have to take it all apart then....it usually snaps when you dont stop the truck before switcthing forward or reverse....:thumbs:

[revofreak]

you need to reset your opti drive that happend with my revo and a t-maxx best way to fix it perenitly is forward only!! but try reseting you opti drive per: instruction booklet its easy!:thumbs:

[AZRCaddict]

He hasnt posted since the end of January so I'm guessing he has it figured out :)

Im going to lock the thread you old thread diggers ;)